Proffie (2-button controls) User Manual

Are you in the right place?

If you're here, we're assuming you want to operate one of the following sabers:

If you are unsure of whether this is the correct manual for you, you can always visit the product page of the lightsaber you purchased from us, and the web page will mention relevant manuals for applicable models. You can also contact us via chat, email us at, or DM us on Instagram @deluxesabers.

Proffie 2.2 Instructions for Use

Button names

  1. PWR (if buttons are the same size, then PWR is the top button. Otherwise, it's the larger button if they are different sizes.)
  2. AUX (if buttons are the same size, then AUX is the bottom button. Otherwise, it's the smaller button if they are different sizes.)


Make sure the battery is installed correctly and you hear a beep, it means the lightsaber is in standby. (It is recommended to remove the battery when not using the lightsaber)

Open Lightsaber: Short press the main button (large button) to open or close the sword.

Silent mode: When the sword is off, double-click the main button to mute the sword.

Somatosensory Open Lightsaber: Turn the handle to turn on/off the lightsaber.

2.With the lightsaber on:

Blaster Block: Click the secondary button.

FOC: When hitting a collision with a lightsaber, it will automatically flash white and make a sound.

Swipe Light: Hold down the home button and hit the tip of the blade.

Background music: long press the main button to turn on/off the background sound.

Switch color: When the lightsaber is turned on, press and hold the secondary button and quickly press the main button. After hearing the beep, slowly rotate the handle to change the color of the light effect. Click the main button and hear the tone to exit the color switching mode.

3.In the lightsaber standby state:

Adjust the volume: Press and hold the main/sub buttons at the same time to enter/exit the volume adjustment mode after hearing the "di" sound, short press the main button to increase the volume, and short press the sub button to decrease the volume.

Toggle sound effects

Click the secondary button.


When the battery runs low, a voice will sound to inform you the battery is low. Insert the charging cable in the DC port. The hilt will have a "pulsing" light indicating that it is charging. Once it is fully charged, the light will either turn off or remain lit and steady to indicate a full charge.

Symptoms of low battery

If you haven't charged it recently, the saber may flash on clash with a red tinge; if you don't notice this or ignore it long enough, the saber will turn off automatically and no longer be powered on OR in wake mode until recharged.