Baselit-4 User Manual

Are you in the right place?

If you're here, we're assuming you want to operate one of the following sabers:

If you are unsure of whether this is the correct manual for you, you can always visit the product page of the lightsaber you purchased from us, and the web page will mention relevant manuals for applicable models. You can also contact us via chat, email us at, or DM us on Instagram @deluxesabers.

Feature overview

4 Soundfont Sets: Luke/Obi-wan/Darth Vader/Anakin
12 Kinds Blade color: Red/Blue/Yellow/Cyan/Ice-Blue/Green/Pink/Orange/Purple/Peak-Green/Rose/White

Turning on/off

Wake mode

This saber has what is called "Wake mode" which is a low-power mode in between being completely off and having the blade actually on (ignited).

To enable Wake mode, hold the button for 1 second.

To turn it back off from Wake mode, hold the button for 6 seconds.

Igniting/Activating The Blade

While in Wake mode, press the button to turn the blade on.

Powering Down The Blade

Hold for 4 seconds; the saber will still be in Wake mode.

Changing Colors

After turning on, press and hold the power button for 2 seconds to enter the Color Selection Mode. You can press the button to cycle through the 12 colors in sequence until you reach the color you want. You can then hold the button down for 2 seconds to "exit" this mode.

Lightsaber effects (saber must be turned on)

Blaster sound: Tap the button.
Lock-up loop: Press the button for 1 second and release your finger. Then press the button to activate lock up. Press it again to end the lock up loop.
Flash-on-clash: The saber will automatically flash white and emit a sound when it hits another surface.

Volume Adjustment

While blade is off (in Wake mode), hold the power button for 1 second to adjust the volume between High, Low, and Mute.

Sound Font Switching

While blade is off (in Wake mode), press and hold the button for 2 seconds to select the next sound font.


When the battery runs low, a voice will sound to inform you the battery is low. Insert the charging cable in the DC port. The hilt will have a "pulsing" light indicating that it is charging. Once it is fully charged, the light will either turn off or remain lit and steady to indicate a full charge.

Symptoms of low battery

If you haven't charged it recently, the saber may flash on clash with a red tinge; if you don't notice this or ignore it long enough, the saber will turn off automatically and no longer be powered on OR in wake mode until recharged.